![]() ![]() WOL utilities typically require the target host's NIC MAC address this can be found by running standard network configuration utilities on the target (e.g. Replace eth0 with your network interface device name: The ethtool command from the ethtool package can tell the network interface to respond to the magic packet. $ sudo nmcli c modify "wired1" 802-3-ethernet.wake-on-lan magic NetworkManager supports WOL since version 1.0.6 and you can enable it from either your desktop network configuration GUI, or the nm-connection-editor GUI from nm-connection-editor, or from the nmcli command-line tool using this command: You can check if your network devices are managed with nmcli d command. The name needs to be lexicographically smaller. link file is applied and that there is a 99-default.link. link file for the network interfaces you want to use WOL on:īeware that only the first. Set the WakeOnLan field to one of the available options in the section of the. You can check if your network is managed by systemd-networkd by networkctl list command. ![]() See the documentation in /usr/share/doc/ethtool/README.Debian for more information.Īdd an interface config file /etc/network/interfaces.d/eth0 (or modify the global interface config file /etc/network/interfaces): Since squeeze ethtool parameters can be set directly from an interface configuration file. This is the default on Debian installations. You can check if you manage network by ifupdown with ifquery. Supported link modes: 10baseT/Half 10baseT/FullĪdvertised link modes: 10baseT/Half 10baseT/Full You can check if WOL is enabled using the ethtool command from the ethtool package: Alternatively you can activate it manually. You can use the integrated WOL functionality of systemd networkd, NetworkManager or ifupdown. If it is not activated, then you need to enable automatic activation. If it is activated, then you can power down your system, and then use another system to wake it. Shuttle XPC SK41G: Power Management Setup -> IRQ/Event Activity Detect -> PowerOn by PCI Card or Modem Ring ResumeĪfter activating WOL in hardware and firmware, it must also be activated in software.įirst check if WOL functionality is already activated. If you do not have that option, there may be another power management or network option that enables WOL. In the UEFI/BIOS boot firmware settings under power management or network you may have a clear, intuitive option labelled "Wake On LAN".
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |